The CompuCarve TM System, with its computer-controlled 3D carving and
general woodworking capabilities, is a revolutionary breakthrough in
bench-top power tool design. This manual will explain the many features
of the CompuCarve machine to help make creative carving operations
pleasant and rewarding.
Safety, performance, and dependability have been given top priority in the
design of the CompuCarve System. Read carefully through this entire
operator's manual before using the new CompuCarve System. Pay close
attention to the Rules For Safe Operation and all Safety Alert Symbols. If
the CompuCarve System is used properly and only for what it is intended,
it will provide many hours of safe, reliable service.
For access to online information about the CarveWright Design Software
visit http://www.carvewriqht.com.
WARNING or CAUTION:
Look for this symbol to point out important safety precautions.
It means attention -- Personal safety is involved!
Look for this symbol to point out helpful information and hints
that will allow maximum efficiency and enjoyment of the
CompuCarve system.
CRAFTSMAN ONE-YEAR LIMITED WARRANTY
If this tool fails due to a defect in material or workmanship within one year or 200 hours of
use (whichever comes first) from the date of purchase, call 1-800-4-MY-HOME ®to
arrange for repair.
Consumable materials are not subject to warranty, and include, but are not limited to the
flex shaft, cutting/routing bits, grit surface drive belts, and lubricants.
Using the machine with unapproved cutting bits will void the warranty.
This warranty gives you specific legal rights, and you may also have other rights, which
vary from state to state.
Sears, Roebuck and Co., Hoffman Estates, IL 60179
Please keep the box and packaging from the CompuCarve machine. This
box will be used for shipping in the event that the unit needs servicing.
Sears, Roebuck and Co. CompuCarve TM System (Rev 1.13) 01/06/07 i
To Next Page
Loading...
Need help?
General
