X/Y axis V wheel adjustment:
Gently dial the V-wheel by hand to check whether it is idling or
stuck. If this phenomenon occurs, use an open-end wrench to
adjust the eccentric isolation column to make it rotate smoothly.
Z axis V wheel adjustment:
Gently dial the V-wheel by hand to check whether it is idling. If this
phenomenon occurs, use an open-end wrench to adjust the
eccentric isolation column counterclockwise so that the V-wheel has
no idling. Power on and click on the interface to return to the origin.
After returning to the origin, move the Z axis separately, and feel
whether the printing platform is stuck. If there is a stuck, adjust the
eccentric spacer clockwise to make it move smoothly.
To Next Page
Loading...
