13
Platform adjustment
1. Prepare → Auto Home, waiting for the Nozzle to move to the left/front of
the platform → Prepare → Disable Steppers (Close stepper drive, release Motor)
2. Move the Nozzle the front/left levelling screw and adjust the platform height by
turning the knob underneath. Use a piece of A4 paper (standard printer paper) to
assist with the adjustment, making sure that the Nozzle lightly scratches the paper.
3. Complete the adjustment of the screw on all 4 corners.
4. Repeat above steps 1-2 times if necessary.
The Nozzle is too far away from the
platform, so the consumables can not
adhere to the platform.
The Nozzle is too close to the platform
and the filament are not extruded
enough, even scraping the platform.
To Next Page
Loading...
