Install the T- shaped fixing block
Note: Make sure that the nut for profile has been turned
by 90° before fastening the T- shaped fixing block.
*CR- 10 mini without T- Bracket (right).
Connect the Stepper Motors according to
the yellow labels on the 6pin (4- wire) side.
Connect the Limit Switches according to the
yellow labels on the 3pin (2- wire) side.
1) Select the correct input voltage to match
your local mains (230 V or 115 V).
2) Damage can occur if voltage is set
incorrectly.
3) Make sure the power cable is connected.
Connect the aviation connectors to the
ports with corresponding pins.
To Next Page
Loading...
