Creality CR-10S Pro V2 - Loading Filament; Replacing Filament During Printing

0
0
38
81
200
0
0
38
81
29 0 29 0
29 0 29 0
29 0 29 0
29 0 29 0
6.Loading Filament
♦ Preheat
Method 1,
Method 2,
..
..
..
Shenzhen Creality 3D Technology C0.,L TD. CRE.ALITV'
♦ Feeding
)
Press and hold the extruder lever and insert the 1.75mm
filament through the filament detector
and through the
extruder motor. Continue feeding until you
see filament
extrude from the nozzle .
Replacing Filament During Printing:
1, Cutting the previous filament near the extruder and slowly
feed new filament though the filament sensor
and extruder, until
the new filament
is fed into the PTFE tube .
(Or)
2, Preheat the nozzle and withdraw the used filament. Feed the
new filament
as pictures above.
6