The nozzle is too far away from the platform, so
the filament cannot adhere to the platform.
Filament are extruded evenly, just sicking on the
platform.
The nozzle is too close to the platform, and the
filament are not extruded enough, even scraping
the platform.
5.
Use a piece of A4 paper (standard printer paper) to assist with the adjustment, making
sure that the nozzle lightly scratches the paper.
Complete the adjustment of the screw on all 4 corners. Repeat above steps 1-2 times if
necessary. Keep adjusting until there is slight resistance on the A4 paper from the
nozzle.
To Next Page
Loading...
