Creality Dual Z - Step 6: Assemble the belt tensioner

EnderExtender.com – Ender Extender™ 5 Installation Guide
Page 20
Step 6: Assemble the belt tensioner
Step
Description
1
Gather required parts
Kit parts:
(2) M5x20 hex cap screws
(2) M5 lock washers
(2) M5 t-slot nuts
(1) 2020 belt tensioner bracket
(1) printed bearing support
(2) 8mm ID flange bearings
(1) M5x40 hex cap screw
(1) M5 flat washer
2
Affix the M5 lock washers to the M5x20
hex cap screws
Insert the M5x20 hex cap screws into the
belt tensioner bracket
Attach the M5 t-slot nuts, leave enough
room for mounting on the printer frame
extrusion
3
Attach flange bearings to the printed
bearing support.
Ensure the flange of the bearing is on the
outer edge (e.g. top/bottom) so that the
belt will ride smoothly in the bearing.