41
Configure Auto Update Settings
To configure Auto Update settings:
1. On the Auto Update page, click the Settings button at the bottom of the page.
The Auto Update Settings page opens. By default, Use Poll Interval is selected.
Auto Update Settings – Use Poll Interval Page
2. Do either of the following:
• Use an automatic polling interval to update the firmware. Refer to “Use
Automatic Polling Interval” below for instructions.
• Set a specific day and time for the firmware to be updated. Refer to “Set Day
and Time” on page 42 for instructions.
Use Automatic Polling Interval
To set an automatic polling interval to update the firmware:
1. On the Auto Update Settings page, select the Use Poll Interval button if it is not
already selected.
2. Set the automatic polling interval by entering the desired value in the Check for
Updates Every Hour(s) text box.
3. Click the Apply Settings button.
4. Click the Back button in the upper-left corner of the page to return to the Auto
Update page.
To Next Page
Loading...
