Crestron TS-70 Series - Configuration

Product Manual — Doc. 8555F TS-70 Series • 81
Configuration
Prior to configuration, ensure the device is running the latest firmware. To update the firmware,
refer to Update Firmware (on page118).
When power is applied for the first time, the following screen is displayed. The touch screen may
take up to two minutes to boot.
NOTE:TS-70Rseries touch screens boot to the Crestron Home application setup screen. For
more information on configuring the Crestron Home application, refer to the Crestron Home
OS™ Product Manual.
Touch the screen to display the main Setup screen (TS-1070 shown)
Device settings for the touch screen may be configured using the built-in setup screens or the
web configuration interface.
l
To configure the device using the built-in setup screens, refer to Local Configuration (on
page82).
l
To configure the device using the web configuration interface, refer to Web Configuration
(on page116).