Crestron TSS-770 User Manual

Product Manual — Doc. 8745C TSS-770 and TSS-1070 • 7
Wi-Fi Setup
Tap Wi-Fi Setup on the Setup screen to display the Wi-Fi Setup screen.
Wi-Fi Setup Screen
Use the Wi-Fi Setup screen to view the Wi-Fi network MAC and IP addresses, subnet mask
address, default router address, primary and secondary DNS addresses, hostname, domain, and
various details about the Wi-Fi connection. A Link indicator is provided to indicate the status of
the Wi-Fi connection. (Green indicates that the Wi-Fi connection is active.)
NOTE:Ethernetmust be disabled before a Wi-Fi connection can be configured.
The following buttons are provided for configuring Wi-Fi settings:
l Tap On or Off under Wi-Fi Access to turn the Wi-Fi adapter on or off. If Wi-Fi Access is set
to Off, Wi-Fi will not function and an Ethernet connection can be established.
l Tap On or Off under DHCP Enable to turn DHCP (dynamic host configuration protocol) on
or off.
NOTE: DHCP is enabled on the touch screen by default.
l If DHCP is turned off, tap Set Static IP Address Settings to enter static IP addresses
manually.
l Tap Set Hostname to enter a new touch screen hostname using an on-screen keyboard.
l Tap APPLY CHANGES to apply any new Wi-Fi settings to the touch screen and to stay in
setup mode.
l Tap REBOOT to exit setup mode and reboot the touch screen.

Crestron TSS-770 Specifications

General

Network Connectivity	10/100 Mbps Ethernet
Operating Temperature	32° to 104° F (0° to 40° C)
PoE	IEEE 802.3af Class 3 (12.95 W)
Memory	2 GB RAM
Display Size	7 in (178 mm) diagonal
Resolution	1024 x 600 pixels
Touch Technology	Projected capacitive
Power	PoE Class 3 (12.95 W)
Ethernet	10/100 Mbps
Mounting	Surface mount
Processor	Quad Core