Crestron TSS-770 - Web Configuration and System Management

Product Manual — Doc. 8745C TSS-770 and TSS-1070 • 23
Web Configuration
The touch screen may be monitored and configured using the included web configuration
interface. The configuration interface is accessible from a web browser if the touch screen IP
address is known. This interface is also accessible using the XiO Cloud® service.
To access the configuration interface:
1. Use the Device Discovery tool in Crestron Toolbox™ software to discover the touch screen
and its IP address on the network.
2. Open a web browser.
3. Enter the touch screen IP address into the browser URL field. The configuration interface
is displayed (TSS-770 shown).
NOTE: If authentication is enabled for the touch screen, an administrator username and
password must be entered prior to accessing the web configuration interface. For more
information on configuring authentication settings, refer to Authentication (on page46).
Web Configuration Interface
The configuration interface provides the following tabs:
l Status:Usedto monitor touch screen status
l Settings:Usedto configure touch screen settings
l Security:Usedto enable authentication and other security settings
l 802.1x Configuration:Usedto configure IEEE 802.1x network authentication for touch
screen security