Crestron TSS-770 - Select Wi-Fi Access Point

Product Manual — Doc. 8745C TSS-770andTSS-1070•9
l Use the keypad to make a new entry.
l
Tap the clear button in the text field to clear any previous entry.
l
Tap the delete button to delete the last digit.
l Tap Save to save a new entry or tap < CANCEL to discard any changes. The display
returns to the Static IP Ethernet Setup screen.
After new settings have been saved, tap APPLY CHANGES on the WiFi Static IP Setup screen to
apply the new settings and stay in setup mode. Tap REBOOT to exit setup mode and reboot the
touch screen.
Tap < BACK to return to the Wi-Fi Setup screen.
Tap < BACK on the Wi-Fi Setup screen to return to the Setup screen.
Select a Wi-Fi Access Point
On the Wi-Fi Setup screen, tap Select Wi-Fi Access Point. The Connect to a Wi-Fi Access Point
(1-2-3) screen is displayed.
Connect to a Wi-Fi Access Point (1-2-3)Screen
Use the Connect to a Wi-Fi Access Point (1-2-3) screen to connect the touch screen to an existing
WAPthatis in range or to configure a new WAP. Any WAPs that are in range and discoverable
are displayed under Step 1 - Select a WAPuponsuccessful discovery.