48
It is imperative to maintain a 150mm clearance around the charger. The installer will take the necessary steps
to ensure that the air temperature is below 65°C around the charger.
The necessary measures will also be taken to allow hot air to escape on either side of the charger.
It is strictly forbidden to place any object on or against the charger.
The charger must not be installed near a heat source. It must be installed in a ventilated area.
The charger's air inlets and outlets must not be obstructed.
Attention hot surface: do not touch the charger during and after its operation (burn hazard).
Measures to prevent dust, run-off and waterfalls
The location of the charger must be chosen to avoid any moisture, liquid, salt or dust entering the
charger.
These incidents could cause irreversible damage to the equipment and potentially endanger the user. The
charger should be positioned in a dry, well-ventilated area.
Precautions regarding inflammable materials
The charger must not be used near flammable liquids or gases.
Batteries are liable to emit explosive gases: when installing batteries, follow the manufacturer's instructions.
Near batteries: ventilate the area, do not smoke, do not use naked flames.
Fuses and ignition protection (protection against flammable gases).
The battery chargers are protected against ignition of surrounding flammable gases according to ISO
8846 standard.
DC output fuses should only be replaced with the appropriate ignition protection fuse:
Label and quantity: see section 5
Manufacturer: Bussmann / EATON
References: ATM 20 /ATM30 /ATM15
Other precautions
Never attempt to drill or to machine the charger's case: this may damage components or cause
metal chips or filings to fall on the charger's board.
Do not do anything that is not explicitly stated in this manual.
6.2 WARRANTY
Failure to comply with the installation and use rules voids the manufacturer's warranty and releases CRISTEC
from any liability
The warranty is valid for 36 months.
To Next Page
Loading...
