Released on 10/31/05 - X800058A UV Pure Technologies Inc. © 2005
No part of this document may be photocopied, reproduced, transmitted, or translated to another language without the
prior written consent of UV Pure Technologies Inc.
For additional info call 1-888-407-9997 or email info@uvpure.com
or visit www.uvpure.com
15
SOLENOID
VALVE
OPTIONAL
DRAIN
20" FILTER
HOUSING
MANUAL SHUTOFF
VALVE - ESSENTIAL
MANUAL SHUTOFF
VALVE - ESSENTIAL
CHECK VALVE
ESSENTIAL
TYPICAL INSTALLATION
OF PARALLEL UNITS
Figure 1E
Plugging in the Hallett
Step 1: Ensure that the covers on the unit have been installed and the unit is
securely fastened to the wall. (Note: You should not remove any cover unless
the unit has been unplugged).
Step 2: Plug the female end of the power cord into the power entry module
located on the underside of the front panel. Note that the power entry module
contains the only fuse for the unit, which can be accessed by pulling out the
sliding fuse drawer. The power cord must be removed before changing the fuse.
See Figure 1B
To Next Page