Released on 10/31/05 - X800058A UV Pure Technologies Inc. © 2005
No part of this document may be photocopied, reproduced, transmitted, or translated to another language without the
prior written consent of UV Pure Technologies Inc.
For additional info call 1-888-407-9997 or email info@uvpure.com
or visit www.uvpure.com
19
3. OPERATING INSTRUCTIONS
The Hallett applies advanced Crossfire Technology, yet is simple to operate.
With automatic quartz cleaning, periodic shutdowns are not necessary to inspect
the cleanliness of the quartz. The only required maintenance is the replacement
of the two UV lamps every 12 months (note - if you shut your system down for
seasonal use - the lamp life will be extended)
Unit Functions
GREEN LIGHT
UNIT SAFE
RED LIGHT
LAMP FAULT
RED LIGHT
WATER QUALITY FAULT
FAUCET AND GLASS
LAMP
WATER NOT CLEAN
HOURGLASS
RESET BUTTON
RESET LAMP TIMER
Figure 2
There are three indicating lights and a pushbutton on the front panel.
See Figure 2.
• At the top beside the FAUCET AND GLASS graphic is a green light that,
when illuminated, indicates the unit is safe or treating normally.
• In the middle beside the LAMP graphic is a red light that, when illuminated,
indicates a lamp fault.
• Near the bottom beside the WATER NOT CLEAN graphic is a red light that,
when illuminated, indicates a water quality fault.
• At the very bottom under the "Hourglass" graphic is a reset button that you
will use after replacing lamps (see Lamp Replacement section for more
detail.) Pressing the button also silences the audible alarm for 24 hours.
Although the audible alarm is off, the red light for the specific alarm will
remain illuminated and the solenoid valve will remain closed. Unplugging and
plugging in the unit will re-enable the audible alarm.
See Troubleshooting Guide for description of faults.
To Next Page
Loading...