Page 61
1 = Send set / unset 5 = Send set at the end of the exit delay (LED On)
2 = Send Stay Mode set/unset 6 = Send all zone restores at disarm only
3 = Send unset only after activation's 7 = Spare
4 = Send Stay Mode unset only after alarm 8 = Spare
Programming Partition “A” Parameters
P290E Time Zones used for Area "A" auto arming /disarming- Default 0 Page 25
Partition “A” Specific Output Options
P291E-P298E OPTIONS
P291E Area "A" specific options for output #1 - Default 0 1 = Any bypass Page 24
P292E Area "A" specific options for output #2 - Default 0 2 = Auto-bypass warning Page 24
P293E Area "A" specific options for output #3 - Default 0 3 = Entry beeps Page 24
P294E Area "A" specific options for output #4 - Default 0 4 = Exit beeps Page 24
P295E Area "A" specific options for output #5 - Default 0 5 = Control Page 24
P296E Area "A" specific options for output #6 - Default 0 6 = Follow Set Arming Page 24
P297E Area "A" specific options for output #7 - Default 0 7 = Follow Stay Arming Page 24
P298E Area "A" specific options for output #8 - Default 0 8 = Follow Unset Page 24
Partition “A” Keypad Options
P299E Arm key can disarm during exit - Default 1-8 Page 25
P300E Stay key can disarm during Stay armed state. - Default l-8 Page 25
P301E Misc partition options 1 - Default = 0 1 = Cannot Arm if not sealed Page 26
2 = “Arm” required before code
3 = “Stay” required before code
4 = Code required to arm
5 = Code required for control
6 = Control toggles
7 = Momentary control
8 = Control/Chime disables day zones
Partition “A” Misc Options
P302E Misc partition options 2 - Default 3,4,6 1 = Key-switch enabled Page 27
2 = Use 2nd Key-switch
3 = Key-switch ARM's/STAY
4 = Pendant chirps when Armed
5 = Pendant chirps when in Stay Mode
6 = 2 sec pulse at set
7 = 2 sec pulse at unset
8 = Access control even when armed
P303E PARTITION "A" TIME AND DELAY OPTIONS-Default = 0 Page 25
1 = Set partition When Time Zone Ends
2 = Unset Partition When Time Zone Starts
3 = Disable Stay Mode Exit Delay
4 = Disable Set Mode Exit Delay
5 = Disable Stay Mode Entry Delay
6 = Disable Set Mode Entry Delay
7 = Use special Stay Mode entry timer
8 = Report Stay Mode alarms & Bypasses via dialer
Miscellaneous System Options “A”
P310E Options - Default 6,8 1 = Ignore Mains fail Page 29
2 = Siren Output on O/P # 1
3 = Siren Output on O/P # 2
4 = Turn Off Alert KP LED’s when armed
5 = Ignore Zone Tampers during exit delay
To Next Page
Loading...
