Crow Arrowhead Elite V6 - Keypad Options

Page 65
P394E Area "B" specific options for output #4 - Default 0 4 = Exit beeps Page 24
P395E Area "B" specific options for output #5 - Default 0 5 = Control Page 24
P396E Area "B" specific options for output #6 - Default 0 6 = Follow Set Arming Page 24
P397E Area "B" specific options for output #7 - Default 0 7 = Follow Stay Arming Page 24
P398E Area "B" specific options for output #8 - Default 0 8 = Follow Unset Page 24
Partition “B” Keypad Options
P399E Arm key can disarm during exit - Default 1-8 Page 25
P400E Stay key can disarm during Stay armed state - Default 1-8 Page 25
Partition “B” Misc Options
P401E Misc partition options 1 - Default 0
1 = Cannot Arm if not sealed Page 26
2 = “Arm” required before code
3 = “Stay” required before code
4 = Code required to arm
5 = Code required for control
6 = Control toggles
7 = Momentary control
8 = Control/Chime disables day zones
P402E Misc partitions options 2 - Default 3,4,6 1 = Key-switch enabled Page 27
2 = Use 2nd Key-switch
3 = Key-switch ARM's/STAY
4 = Pendant chirps when armed
5 = Pendant chirps when in Stay Mode
6 = 2 sec pulse at set
7 = 2 sec pulse at unset
8 = Access control even when armed
P403E PARTITION "B" TIME AND DELAY OPTIONS Page 25
1 = Set partition When Time Zone Ends
2 = Unset Partition When Time Zone Starts
3 = Disable Stay Mode Exit Delay
4 = Disable Set Mode Exit Delay
5 = Disable Stay Mode Entry Delay
6 = Disable Set Mode Entry Delay
7 = Use special Stay Mode entry timer
8 = Report Stay Mode alarms & Bypasses via dialer
Soak-Test Zones
P408E SOAK-TEST ZONES - 1-8 Page 30
P409E SOAK-TEST ZONES - 9-16 Page 30
Single or Dual Zone Input (8 or 16 Zones)
P410E Single or dual zone input - Default-All Off (zones 1-8 only) Page 30
Vibration Sensor Zone Sensitivity Settings (Zones 1-8)
P411E Zone 1 vibration sensitivity - Default 0 0 = No vibration sensor Page 30
P412E Zone 2 vibration sensitivity - Default 0 Sensitivity 1-8 Page 30
P413E Zone 3 vibration sensitivity - Default 0 1 = High sensitivity Page 30
P414E Zone 4 vibration sensitivity - Default 0 8 = Low sensitivity Page 30
P415E Zone 5 vibration sensitivity - Default 0 Page 30
P416E Zone 6 vibration sensitivity - Default 0 Page 30
P417E Zone 7 vibration sensitivity - Default 0 Page 30
P418E Zone 8 vibration sensitivity - Default 0 Page 30
Zone End of Line Options
P419E Zone End-of-Line Options default = All On (Inputs 1-8 require EOL resistor) Page 30