Page 29
pendants. To prevent confusion, if a pendant is set to control an output or provide instant Panic, then you should
turn off any Arm or Disarm options at addresses P151E-P158E.
P161E-Pendant #1 Options 1E Turn output ON - Default off
2E Turn output OFF - Default off
3E Visonic Powercode Battery Low - Default off
4E Spare - Default off
5E Report Pendant Panic To Dialer - Default off
6E Immediate Panic Alarm - Default off
7E Delayed Panic Alarm (1.5 Seconds) - Default off
8E Ness Battery Low - Default off
Option 1 Turn Output On - This option allows the pendant to turn an output on. The output the pendant will
turn On is programmed at address P101E-P108E. If the output reset time is set to Latched operation
(set to “0”) then you must also program Option 2 to the pendant to allow for turning the output Off.
Option 2 Turn Output Off - This option allows the pendant to turn an output off. The output the pendant will
turn Off is programmed at address P101E-P108E. For this option to work, option 1 above must also
be assigned to the pendant to allow the pendant to first turn the output on before it can turn it off.
Option 3 Visonic Powercode Battery Low - If a Visonic Powercode Transmitter with battery low monitoring is
used on the PW-4, setting this option will allow the battery signal to be correctly recognised.
Option 4 Spare
Option 5 Report Panic to Dialer- This option enables a panic alarm from a pendant to be sent via the dialer to
a Monitoring Station.
Option 6 Immediate Panic Alarm - If this option is on, pressing the pendant button will produce a pendant
panic alarm. The Panic alarm can also be silent at the keypad or sound the keypad buzzer (see
P175E)
Option 7 Delayed Panic Alarm- If this option is on, the pendant button must be pressed continuously for 1.5
seconds or longer to produce a pendant panic alarm.
Option 8 Ness Battery Low - If using a Ness pendant with battery low reporting, this option must be turned on
to allow the battery low signal to be recognized properly.,
Note: P162E through P168E are as above but applied to pendants 2-8
KEYPAD PARTITION ASSIGNMENT
A keypad must be assigned to a Partition before it can control the Partition (ie to allow Arm/Disarm facilities).
P171E Keypads Assigned to Partition “A” - Option Keypad 1-8 (Default = All keypads 1-8)
P172E Keypads Assigned to Partition “B” - Option keypad 1-8 (Default = None)
Pendant 1 Opt B
- - - - - - - -
KeyPad in A
1 2 3 4 5 6 7 8
To Next Page
Loading...