Page 41
PROGRAMMING TELEPHONE NUMBER REPORT OPTIONS
This block of addresses (P181E - P184E) are used to set the reporting options for each telephone number
P181E-Telephone #1 Options 1E Stop if Kissed Off - Default on
2E Stay Call Progress - Default on
3E Blind Dial - Default off
4E Use Group Codes or Multiple Accounts - Default off
5E Send Restores - Default on
6E Send test Call to Monitoring Station - Default off
7E Spare - Default off
8E Spare - Default off
Option 1 Stop if Kissed Off– If this option is turned on for the telephone number, the dialer will stop sending the
alarm if the signal is kissed off and will not proceed with any other telephone numbers for that event. If
not kissed off the dialer will continue for the maximum dial re-tries then cease reporting the alarm. If the
event is not kissed off and the maximum re-tries limit is reached then the event is marked as unsent and
will be added to the next event that causes the dialer to report. If this option is not turned on, the dialer
will send the event for the maximum re-tries count or until kissed off but it will then proceed with any
other telephone numbers also programmed.
Option 2 Stay Call Progress - Stay call progress means that the dialer monitors the status of the dialing tone to
determine whether the call is valid or not. If the call is not valid, i.e. Engaged, the panel will know and
hang up the call and try again.
Option 3 Blind Dial - When the dialer makes a call it looks for dial tone before making the call. If no dial tone is
detected the panel hangs up and attempts another call. The panel will do this 3 times and if dial tone is
still not detected it will make the call anyway. If blind dial is on, the panel skips the dial tone detection
and dials 2 seconds after looping the line. (used where non standard or low level dial tone exists)
Option 4 Use Separate Accounts or Group Number - When sending an alarm using Contact ID, the panel can
either send separate account codes to report the two partitions (the default setting LED 4 Off) or, use
one account code (Partition A) and use the group number to identify the two partitions.
Option 5 Send Restores - When an alarm is generated the panel automatically sends a restore when the alarm
is reset. If the monitoring company does not want restores they may be turned off with this option.
Option 6 Send Test call to Monitoring Station - The automatic daily test call to a monitoring station can be
disabled if not required by turning off this option.
Note: P182E through P184E are as above but applied to telephone numbers 2-4
CONTACT ID or 4+2 ACCOUNT CODES
The account code is the 4 digit number that identifies the panel to the Monitoring Station. If send Group numbers is
set for Contact ID then the account number used is Partition “A”. The special characters B,C,D,E & F can be entered
at these addresses if required (see the table on page 32 for instructions).
P506E Account Code For Partition “A” - Value = 4 character code (Default = 0000)
P507E Account Code For Partition “B” - Value = 4 character code (Default = 0000)
Tel 1 Options
1 2 - - 5 - - -
Account No B
To Next Page
Loading...