Crow PowerWave-4 - Page 50

Page 50
P94E Zone Tamper 1-8 to Output # 4 (Default= None) Page 17
P95E Zone Tamper 1-8 to Output # 5 (Default= None) Page 17
P96E Zone Tamper 1-8 to Output # 6 (Default= None) Page 17
P97E Zone Tamper 1-8 to Output # 7 (Default= None) Page 17
P98E Zone Tamper 1-8 to Output # 8 (Default= None) Page 17
Mapping Radio Keys To Outputs
P101E Radio Key 1-8 to Output # 1 (Default= None) Page 18
P102E Radio Key 1-8 to Output # 2 (Default= None) Page 18
P103E Radio Key 1-8 to Output # 3 (Default= None) Page 18
P104E Radio Key 1-8 to Output # 4 (Default= None) Page 18
P105E Radio Key 1-8 to Output # 5 (Default= None) Page 18
P106E Radio Key 1-8 to Output # 6 (Default= None) Page 18
P107E Radio Key 1-8 to Output # 7 (Default= None) Page 18
P108E Radio Key 1-8 to Output # 8 (Default= None) Page 18
Temporary Output Disable
P109E Temporary Output Disable - Output 1-8 Page 18
Partition “A” Options
P110E Partition “A” Options P110E Options Page 18
(Default= 4 & 5) 1 = Arm Button Required Before Code to Set
2 = Stay Button Required Before Code to Set Stay Mode
3 = Code required to Set
4 = Arm Button can disarm during Exit Delay
5 = Stay Button can disarm Stay Mode at any time
6 = No Exit beeps to Keypads in Stay Mode
7 = Enable Key-switch
8 = Key-switch Mode
Partition “A” Output Options
P111E Area “A” Opt. O/P # 1 (Default= None) P111E-P118E Options Page 19
P112E Area “A” Opt. O/P # 2 (Default= None) 1 = Arm Status to Output
P113E Area “A” Opt. O/P # 3 (Default= None) 2 = Stay Arm Status to Output
P114E Area “A” Opt. O/P # 4 (Default= 7) 3 = Disarm Status to Output
P115E Area “A” Opt. O/P # 5 (Default= None) 4 = Pendant Chirps on Arm
P116E Area “A” Opt. O/P # 6 (Default= None) 5 = Pendant Chirps on Stay Mode Arm
P117E Area “A” Opt. O/P # 7 (Default= None) 6 = Pendant Chirps on Disarming
P118E Area “A” Opt. O/P # 8 (Default= None) 7 = Pulse on Arming to Output
8 = Pulse on Disarming to Output
Partition “B” Options
P120E Partition “B” Options P120E Options Page 20
(Default= 4 & 5) 1 = Arm Button Required Before Code to Set
2 = Stay Button Required Before Code to Set Stay Mode
3 = Code required to Set
4 = Arm Button can disarm during Exit Delay
5 = Stay Button can disarm Stay Mode at any time
6 = No Exit beeps to Keypads in Stay Mode
7 = Enable Key-switch
8 = Key-switch Mode