NOTE:You may not receive the call if you set a high “squelch off” level of the transceiver.
If current channel has been programmed with signaling, you can only hear the call from the same
signaling, other calls can not be heard.
Transmitting
Be sure that the channel you want to use is not in busy state through monitoring for a while by
pressing the programmed Squelch off [PF1] key. Under these conditions, press the [PTT] key and
speak into microphone. Please keep around 2.5-5cm distance between microphone and your lip. And
please speak in normal tone to make the receiver obtain best tone quality.
Note：
Holding [PTT], red LED lighting, the transceiver is transmitting. Release the PTT to receive.
Battery Enquiry
Under standby state, pressing [PF2], LCD displays current battery voltage. Press this key again
to clear the display.
BASIC OPERATIONS
To Next Page
Loading...