Channel Scan
Under relevant mode, after pressing key, the top left corner of LCD
displays F icon and then press
key to begin frequency scan or channel
scan.
2. Channel Scan
When the radio is in channel mode, users can start this function to monitor
signal of all channels. Press any number or
key to exit.
NOTE:
●
When channel scanning, the skipped channel is not in the line of scan. Scan up as per channel no.. (
Please refer to channel scan skip.)
●
Channel scan can change scan direction by pressing key or key. When finding a matching
carrier wave and signaling, the transceiver will be stop for 15 seconds and then going on scan.
(Please refer to scan setup).
Add/delete scan list
In channel mode, press key to enter FUNC setting. Then, press key to add current channel
into scan list or delete current channel from the scan list.
1. When “A” is displayed on the LCD, it means that current channel is added into the scan list and
will be scanned.
2. When “A” disappears, current channel is deleted from the scan list and wont be scanned.
SHORTCUT OPERATIONS
To Next Page
Loading...