key to exit.
When the signaling of current channel is setup as CTCSS, the radio scans CTCSS only. Likewise, the
radio scans DCS when the signaling is DCS.
SHORTCUT OPERATIONS
On/Off Beep Prompt
Priority Scan
Under channel mode, after pressing
Under standby state, press
key to enter FUNC setting with F icon displayed on the LCD. Then,
press button to activate and de-activate beep sound. Repeat the above operations to turn on it.
We suggest turn on BEEP for fault detecting and prompt for not proper operation.
CTCSS/DCS Scan
Press key to enter FUNC setting with F icon displayed on top left of the LCD. Then, press
.
.
key to enter CTCSS/DCS scan state. Namely, users can press key to change scan direction.
When matching signaling is detected, scan pauses for 15s before continuing scanning. Press any key
except
、
!
、
key, the top left corner of LCD
displays
and then press key to enter priority scan. Under priority scan
state, it tests priority channel once scanning per 10 channels. When the priority
channel receives a matching signaling, transceiver will stop scanning until
current signal disappear (Please refer to scan setup.).
NOTE: If you want to have this function available, you should set priority
channel, otherwise, this operation will be only as general channel scan.
To Next Page
Loading...