Vorwort
VX 570 English V1.10 Page 2 of 44
I. Forword
Read these operating instructions carefully and completely before
installation, start-up and maintenance work. Follow the instructions to
ensure safe operation and proper functioning.
The operating instructions must always be available at the place of use. It
is not permitted to make only individual pages available.
Important notes for installation and maintenance personnel
Installation of the flow sensor is only permitted by trained skilled staff
with knowledge and experience in compressed air and electrical
engineering.
Electrical connection, commissioning and maintenance may only be
carried out by qualified electricians in accordance with the
electrotechnical regulations (DIN EN 50110-1, DIN EN 60204-1 etc.).
Prerequisite: Professional training and knowledge of the technical
standards, EU directives and EU regulations.
Observe applicable national accident prevention regulations and
ordinances. Observe general occupational health and safety
measures,
E.g. wear suitable and prescribed personal protective equipment
(PPE). Repairs and adjustments may only be carried out by the
manufacturer.
Duties of the installer and plant operator
The flow sensor must be checked and maintained regularly by an
instructed and qualified person.
Cleaning and maintenance intervals are to be determined by the plant
operator according to DIN-ISO certification - frequency depending on
ambient conditions and expected impairments.
Calibration: As part of DIN ISO certification, have the flow sensor
calibrated at regular intervals, after 2 years at the latest.
Remove the flow sensor for calibration and send it to CS Instruments
GmbH & Co.KG.
To Next Page
Loading...
Need help?
General
