MAINTENANCE INTERVALS
160
5. After all of the oil has been drained, close the oil
drain by pushing it in.
6. Remove the drain hose.
7. Place the cap back on the oil drain.
8. Fill engine with new oil. Use a good quality
10w30 motor oil that meets the specifications
recommended by Kohler.
9. Check the dip stick to verify that the oil is at the
proper level before returning to service.
Oil filter
To replace the oil filter:
1. Drain the oil by following the previously
described steps.
2. Remove the oil filter by turning it counter-clock-
wise, as seen from the rear of the filter.
3. Place a light coating of oil on the O-ring of the
new filter.
4. Pre-fill the new filter with fresh, clean oil.
5. Thread the new filter on to the engine. Hand
tighten only.
6. Fill the engine with oil.
7. Test run the engine and check for leaks before
returning to service.
Figure 9.8
Oil filter
Fuel filter
To Next Page
Loading...
Need help?
General
