Cube EPO pedelec User Manual

10
BEFORE EVERY RIDE
Your CUBE EPO pedelec has undergone numerous tests during pro-
duction and a nal check has been carried out by your CUBE dealer.
Nevertheless, be sure to check the following points before every ride
to exclude any malfunctioning that may be due to the transport of
your CUBE EPO pedelec or to the work a third person may have per-
formed on your CUBE EPO pedelec before delivery:
1. Are the quick-release levers
(a) , the bolted connections and the
Pinhead®-locking system (if mounted) of the front and rear wheel,
the seat post
(b) and other components properly closed and
tightened?
For more information see chapters “How to Use the Pinhead®-
Locking System” and “Operate the quick-release action” of
your general CUBE handbook and the enclosed operating in-
structions.
2. Are the connections of the rechargeable battery
(c) , the display
and the drive correctly plugged?
For more information see chapters “Rechargeable Battery” and
“Display Control and Operation”.
3. Is your battery fully charged? Keep in mind to entirely recharge
the battery after every ride. You should not wait until the battery
is empty!
For more information see chapter “Charging the Rechargeable
Battery”.
4. Does the display show all values? Is there any error message or
warning on the display? Check the values are correct on your dis-
play before every ride. Do not set o on your CUBE EPO pedelec
when the display shows a warning.
For more information see chapter “Display Operation and Con-
trol”.
5. Is the battery tight in its holder
(d) and the lock of the Pinhead®-
locking system properly closed? Never set o with a loose and
unlocked battery.
For more information see chapter “Fastening the Rechargeable
Battery”.
b da c
Cube_EPO_Gesamt_EN_2011-05.indd 10 11.05.2011 10:11:25

Cube EPO pedelec Specifications

General

Brand	Cube
Model	EPO pedelec
Category	Bicycle
Language	English