Cube EPO pedelec User Manual

26
A
Do not try to rebuild or disassemble the charger.
A
Do not use further a rechargeable battery with damaged
housing or a damaged charger (mains plug, housing, ca-
ble)
(a) .
i
Do not dispose of the rechargeable battery with normal
household rubbish. There are special disposal systems for
rechargeable batteries. Contact your CUBE dealer.
A
Unintended switching on of the drive can result in injuries.
Therefore, always remove the rechargeable battery be-
fore doing any mounting or servicing on your CUBE EPO
pedelec.
A
Damaged electric assemblies and cables can result in
short-circuits and must be replaced by a CUBE dealer.
A
Use the rechargeable battery for your CUBE EPO pedelec
only.
b da c
Seat Post Option
Removing the Rechargeable Battery
Before removing the seat post battery, make sure the magnetic
connector is no longer connected to the charging socket of the re-
chargeable battery
(b) . You can disconnect the magnetic connector
that leads from the drive to the battery with a slight jolt.
Note the marking on the seat post rear
(c) and memorise the height
that is adjusted to your needs, before removing the seat post.
Subsequently, open the Pinhead®-locking system at the seat post
clamping
(d) of your CUBE EPO pedelec, as described in chapter
“How to Use the Pinhead®-Locking System“, and remove the seat
post battery carefully
(e) .
Release the magnetic connector at the bottom end of the seat post
battery and make sure the cable keeps out of the seat tube
(f) . You
can hook the cable connector into the recess at the rear top end of
the seat tube
(g) .
Cube_EPO_Gesamt_EN_2011-05.indd 26 11.05.2011 10:11:29

Cube EPO pedelec Specifications

General

Brand	Cube
Model	EPO pedelec
Category	Bicycle
Language	English