Cubicon Style Plus-A15 Series - Page 17

CUBICON Style Plus-A15 Series User Manual
※ Names of Each Part on the Exterior of the Rear Part of the Printer (Back)
[1] Auto Feeding
Device
A device that supplies
filament automatically
[2] Spool Holder
Mounting Hole
A spool holder
mounting hole for
mounting the filament
spool
[3] NFC
It is used for checking
the type of a filament
and the remaining
amount.
[4] Power Inlet
A terminal that is
used to connect the
power to the printer
Do not plug in the power cord with a wet hand. There is a risk of electric shock.
17