4
CUES Inc., MPlus+ User Manual | CH905
www.cuesinc.com, | salesinfo@cuesinc.com
OPERATING THE SYSTEM
MPLUS FUNCTIONS:
ON/OFF SWITCH - ILLUMINATED
• BLUE LED indicator operates when system is ON.
BATTERY CHARGE STATUS LED INDICATORS
• YELLOW indicates the battery is charging.
• GREEN indicates the battery is fully charged.
• RED indicates battery charging fault. If this occurs, reset the power and verify.
If RED is still displayed after resetting, contact CUES for service.
• RED/YELLOW/GREEN LED indicators will be displayed while the system is being
charged, even if the system is OFF.
SYSTEM INTERFACE
LOW BATTERY INDICATORS
• The display of the battery gauge is selectable from the system menu.
• A low battery indicator will be displayed on the monitor at %
remaining power, even if battery gauge OFF is selected in the system menu.
• A low battery indicator will ash on the monitor at % remaining power.
• The LCD display will power down at % remaining power.
Note that the battery gauge is always displayed at startup for a few
seconds, regardless of the state of the battery gauge ON/OFF setting.
SYSTEM FAULTS
If the system encounters a problem, or the operator makes a selection which
changes one of the settings, a message is displayed for a short amount of time
(usually only a few seconds) on the rd line from the bottom of the display. The
system is completely active during display of these messages.
A list of the messages currently available is provided in Appendix A.
To Next Page
Loading...