EasyManua.ls Logo

Culligan C100 - Page 37

Culligan C100
61 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
C100 Manual
Page 36 - Revision:EU-2020-10-13
Sanitising
Sanitise using Aquadosa or a 5.25% Sodium Hypochlorite solution or other approved cleaner
throughout the cold and sparkling water circuits. Follow all instructions on the sanitiser and flush
with fresh water through the faucet until odour and taste is acceptable.
WARNING! USE PROPER PERSONAL PROTECTIVE EQUIPMENT
Always ensure proper ventilation and use proper personal protective equipment such as gloves
and eye protection when using chemicals. Refer to Material Safety Data Sheet for specific
requirements of each chemical product. Take all necessary precautions to prevent sanitiser
from contacting eyes, clothing, and any other surfaces (it could damage carpets).
4. Mix 60ml of Aquadosa sanitiser per directions or follow manufactures instructions. Always
ensure sanitiser is compatible with stainless steel and acetyl plastic.
5. Pour sanitiser solution into an empty filter housing. You may add concentrated sanitiser directly
into empty cold tank instead of premixing. Connect to the bulkhead fitting located on the back of
the C100 Water Treatment System.
6. Connect 2.7-4 Bar regulated, potable water supply to the filter housing with the sanitising
solution in. Turn on water supply and check for leaks.
DANGER! ELECTRICAL SHOCK HAZARD.
Do not plug in unit unless qualified. Only qualified personnel who have read and understand
this entire manual should attempt to install or service this unit.
7. Connect C100 Water Treatment System to power.
CAUTION! NEVER TURN ON HEATER BEFORE FILLING HOT TANK.
Red Heater and Compressor Power Switch must be in the O=OFF position
while the hot tank is empty. Damage could occur within one minute and the
overheat (high limit) will require manual reset if heater is turned on with an
empty hot tank.
Fill the Cold Circuit with Sanitiser
8. Depress the main dispensing button on the front control panel until cold water/sanitising solution
comes out the faucet. NOTE: Container and drain basin will be required to catch the water from
the faucet.
WARNING! Use Personal Protective Equipment. Gloves and Eye Protection Required. The first
2 or 3 litres of water will contain concentrated sanitiser. Use extreme care!

Related product manuals