Culligan GBE - Customizing the Setup; Default Settings; Advanced System Set-up Menu

Customizing the Setup 28
27 CULLIGAN GLOBAL ELECTRONIC CONTROLLER
The controller is designed to simplify the setup and installation process by making some default recommendations
during the Initial Setup. The default settings are designed to be appropriate for most common installations.
Default Settings
Downflow Brining
2
Standard Mesh Resin
1
Blue/Beige Eductor
1
0.45 GPM Brine Flow Control
1
0 PPM Iron
1
> 40 psi water pressure
1
NaCl Salt
1
Time of Regen = 2:00 AM
2
Regen Time = Delayed
2
Dosage (calculated)
2
Predict Mode ON
3
30% Reserve Capacity
2
Time Clock Backup = OFF
3
Day-of-week Regen = OFF
3
Pre-Rinse Mode = OFF
1
1
= these items are changed on the Main Menu / Advanced / System Setup Menu
2
= these items are changed on the Main Menu / Advanced / Regen Setup Menu
3
= these items are changed on the Main Menu / Advanced / Regen Trigger Menu
There may be times when the installer would prefer to override the default regeneration selections. See
Advanced Setup Menu, Regeneration Setup Menu or Regeneration Trigger Menu for information on changing
default selections.
Advanced System Set-up Menu
• Press the UP „ or DOWN ‰ arrow to scroll to menu item
• Press the CHECKMARK P key to select a menu item
• Press the UP „ or DOWN ‰ arrow to change a selection
• Press the CHECKMARK P key to save your selection
Default Values are shown for each selection
Scroll to ADV SETUP and select
Select SYSTEM SETUP
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
system ok
7:32 am 2-1-08
> 5) Adv Setup
> 1) system Setup
Customizing the Setup