14 | CURBTENDER, INC
3
Operation
This section will provide all of the instructions necessary to operate the Quantum Compact. However,
prior to attempting any operation of the unit, make sure you are familiar with all of the safety informa-
tion contained in Section 2, SAFETY PRECAUTIONS.
There are only a few controls required for the complete and e cient operation of the Quantum
Compact. It is important that you know the location and function of each control before attempting
to operate the unit. Refer to the accompanying illustrations for their locations.
MAIN CONTROL BOX
1) SYSTEM ON SWITCH- This switch enables/ disables the PTO and engine acceleration circuit.
2) SYSTEM ON LIGHT- The system on light is illuminated whenever the system is on.
3) TAILGATE OPEN LIGHT- The tailgate open light is illuminated whenever the tailgate is not
closed.
4) STROBE OR BEACON SWITCH- This switch is a standard optional toggle switch allowing a
strobe light to be installed.
5) WORK LIGHT SWITCH- This switch is an optional toggle switch allowing a work light to be
installed.
6) PTO LIGHT- The PTO light is illuminated whenever the PTO is engaged.
7) PTO OVER SPEED LIGHT- This indicator light illuminates when the PTO shaft is operating too
fast. Take precautionary safety measures when this happens (i.e. decrease system load, lower
throttle, or even shut of hydraulic system).
8) CONTROL BOX BRACKET- This secures the control box into position. To adjust, loosen both
wing nuts, angle to desired position, and then tighten the wing nuts.
THE FOLLOWING INFORMATION IS FOR DESCRIPTIVE PUR-
POSES ONLY AND IS NOT TO BE MISCONSTRUED AS OPERAT-
ING INSTRUCTIONS. REFER TO OPERATING PROCEDURES LATER IN THIS SECTION.
To Next Page
Loading...