50 | CURBTENDER, INC
TAILGATE SEAL REPLACEMENT
1) Raise the tailgate to a su cient height to extend the tailgate props. Slowly lower the tailgate
until the tailgate props are supporting the tailgate. Remove the keys from the ignition, use
proper lock-out/ tag-out procedures, and chock the tires.
2) Using a small pry bar, bend the metal seal channel upward in those areas where the channel is
depressed into the rubber seal.
3) Grasp one end of the rubber seal and pull outward to remove the rubber seal from the metal
seal channel.
4) Thoroughly clean dirt and debris from the inside grooves of the metal seal channel. Insert
one end of the rubber seal into either end of the metal seal channel. Continue pushing/
pulling the rubber seal through the entire width of the metal seal channel.
To Next Page
Loading...