CURBTENDER Quantum Compact - Push out Panel Guide Blocks

SERVICE & REPAIR | 51
REPLACING PUSH-OUT PANEL GUIDE BLOCKS
1) Begin with the push-out panel in the fully extended position.
2) There are four push-out panel slide blocks. Replace them one at a time.
3) Remove the slide block retaining bolt and remove the retainer.
4) The forward slide blocks should slide out rearward, and the rear slide blocks should slide
out forward.
5) For installation, simply perform the above procedures in reverse order.
Removing the push-out panel slide blocks may require some
manipulation of the push-out panel itself. The push-out panel
is EXTREMELY HEAVY. Use caution when removing the slide blocks, and DO NOT place your  ngers in
any pinch points between the push-out panel and body.