GENERAL REPAIR | 25
REASSEMBLY AND INSTALLATION
1) Assemble parts in the same position as removed.
2) Align parts accurately before mating.
3) Inspect o-ring and seal grooves for sharp edges, nicks or burrs before installing new sealing
parts.
4) Lubricate all new sealing parts with clean, fresh hydraulic fl uid before installation.
5) Use care not to damage new sealing parts on reassembly.
6) Use correct torque values when reassembling and installing components. See CAPSCREW
MARKING AND TORQUE VALUES later in this section.
7) Always check the hydraulic fl uid level in the hydraulic reservoir after performing any service or
repair of the hydraulic system.
8) Always lubricate components with grease fi ttings after they have been repaired and
reinstalled.
9) Use only Curbtender replacement parts for critical components, such as hydraulic cylinders,
pumps, solenoids, OEM body panels, and proprietary Curbtender parts. Refer to page 7 for
more information on Curbtender parts and ensuring high quality.
To Next Page
Loading...