18 | CURBTENDER, INC
WALK AROUND INSPECTION
Preventative maintenance is the key. Be alert and conscientious- report any malfunction, need for
adjustment, or necessary repair to your Garage or Maintenance Department without delay.
EACH DAY, before beginning work, check the following:
1) LIGHTS AND WIRING
A) Headlights, Tail Lights, and Clearance Lights
B) Turn Signals and Hazard Warning Lights
C) Brake Lights and Backup Lights
D) Hazard Warning Beacon Lights (if applicable)
E) Hopper Work Lights (if applicable)
F) “System On” illuminates one the in-cab control panel when the system power is on
G) “Tailgate Open” light illuminates when the tailgate is raised
H) Check all wiring for cut or frayed wires
2) HYDRAULIC SYSTEM
A) Check for uid leaks:
The oil should be between FULL and ADD on the tank sight gauge, with the vehicle in
the following position:
i) Vehicle on Level Ground
ii) All Hydraulic Cylinders in Fully Retracted Position
iii) Engine/PTO O
B) Start the engine and operate the packing function two or three times. (REFER TO
SAFETY WARNINGS IN THIS MANUAL AND ON TRUCK BEFORE OPERATION)
C) Return the vehicle to the position described in (A) and recheck oil
D) Add oil as necessary
AVOID CONTAMINATING THE HYDRAULIC SYSTEM! KEEP AREA
AROUND SYSTEM COMPONENTS CLEAN OF DIRT AND DEBRIS BE-
FORE DISCONNECTING OR REMOVING. ALWAYS FILL RESERVOIR THROUGH A 200 MESH (OR FINER)
SCREEN. NEVER USE CLOTH TO FILTER OIL!
PROLONGED EXPOSURE AND REPEATED CONTACT WITH
HYDRAULIC OIL MAY CAUSE SERIOUS SKIN DISORDERS, IN-
CLUDING DERMATITIS AND CANCER. AVOID CONTACT WITH SKIN AS MUCH AS POSSIBLE, AND WASH
THOROUGHLY AFTER ANY CONTACT.
To Next Page
Loading...