User Guide DDOC0199-000-A9
1-Slot Data Transport System (CSfC) 6 - 12 Encryption
© 2024 Curtiss-Wright Defense Solutions Revision 3.0
6.4.1.5 Delete SWE Container (Unpartitioned Disk)
CAUTION
LOSS OF CONTENT. Deletion of the SWE container will result in making the stored content
unrecoverable.
• Delete SWE container
Command:
rmcctl -D
scryp = 0
Example
6.4.2 Partitions
NOTE
Refer to paragraph 6.1.2 Software Layer Passwords / Passphrases for requirements.
Partitions can have the same or different passwords / passphrases assigned.
6.4.2.1 Initialize SWE Containers (Partitions - Different Passphrases)
CAUTION
DATA LOSS. Initializing the software encryption layer will overwrite / destroy any existing data on
the partition. As a result the --force option must be used.
1. Partition drive. Refer to paragraph 8.5.1 Preparation for Partition and paragraph 8.5.2
Partition Disk for information.
2. Initialize the SWE container on partition 1 of a 100GB RMC module as follows:
a. Type rmcctl -p 1 --force -C and press E
NTER key.
NOTE
After the above command has be issued, the user must acknowledge that all data on the partition
will be overwritten
b. At the overwrite query prompt type YES and press E
NTER key.
NOTE
Refer to paragraph 6.1.2 Software Layer Passwords / Passphrases for requirements.
3. Enter a password / passphrase that complies with the password / passphrase requirements
and press E
NTER key.
4. Reenter the password / passphrase and press E
NTER key.
If the passphrase is entered correctly both times and meets the requirements the following
message will be displayed: RMC_C0; action=cryp status=OK.
Example
5. Verify SWE container is initialized.
Command:
rmcctl
If SWE container is initialized, partition 1 (p# 1) scryp = 1
cw_dts> rmcctl
[rmcctl]
RMC_S#: ins hcryp osdr p# size serv scryp osdm fmt mnt rem mntpoint
*********************************************************************************
RMC_S0: 1 1 1 -- 100GB NAS
0 0 0 0 0 rmc0
[!rmcctl] OK
cw_dts> rmcctl -p1 --force -C password1 / passphrase1
[rmcctl]
Please verify password: password1 / passphrase1
RMC_CO; action=cryp status=OK
[!rmcctl] OK
To Next Page
Loading...