User Guide DDOC0199-000-A9
1-Slot Data Transport System (CSfC) 7 - 4 Quick Start
© 2024 Curtiss-Wright Defense Solutions Revision 1.0
NOTE
To partition a drive, the number of partitions (-P 1, -P 2, etc.) and their size (in either percentage or
physical size [i.e 10GB, 100GB, etc.) must be contained in the command. For the purpose of this
Quick Start Guide, the RMC module has only 1 partition and it encompasses the entire drive.
NOTE
If any services / boot services are active, they must be turned off before partitioning / making
changes to the state of the RMC module. If required, type serv -s 0 --all 0 and press
E
NTER.
9. Create partitions. Type rmcctl -s 0 -P 1 100% --force and press ENTER.
NOTE
The RMC module must have services assigned before SWFDE layer can be initialized.
10. Assign service: rmcctl -s 0 -p 1 --serv NAS and press E
NTER.
NOTE
Refer to paragraph 13.3.24 rmcctl for information regarding rmcctl command results.
11. View RMC module status. Type rmcctl and press E
NTER.
NOTE
DTS1+ CSfC units require use of SWFDE in addition to HWFDE.
NOTE
Disks cannot be partitioned after SWFDE has been performed.
12. Initialize SWFDE. Type rmcctl -s 0 -p 1 -C and press E
NTER.
A warning will activate that SWFDE will overwrite all data.
13. When prompted about data overwrite, type: YES and press ENTER.
NOTE
SWFDE passwords / passphrases must be:
• 15 to 512 characters long
• Use at least 1 upper case, 1 lower case, 1 number, and 1 special character
• Repeat no character more than 3 times
• Have no more than 4 consecutive characters from a character class (i.e lower case, upper
case, etc.)
• If using a password, it must pass dictionary test
14. When prompted, enter password / passphrase to be used for activation of SWFDE.
15. Reenter the SWFDE password / passphrase to verify it.
16. Open SWFDE container. Type: rmcctl -s 0 -p 1 -E and press E
NTER.
17. When prompted, enter same SWFDE password / passphrase as previously entered.
18. Format / mount drive. Type rmcctl -s 0 -p 1 -F -M and press ENTER.
NOTE
Refer to paragraph 13.3.24 rmcctl for information regarding rmcctl command results.
19. View RMC module status. Type rmcctl and press E
NTER.
DTS1+ CSfC is ready to use with CSfC encryption.
cw_dts> rmcctl
[rmcctl]
RMC_S#: ins hcryp osdr p# size serv scryp osdm fmt mnt rem mntpoint
*********************************************************************************
RMC_S0: 1
1 1 1 XX GB NAS 0 na 0 na 0 rmc0p1
[!rmcctl] OK
To Next Page
Loading...