User Guide DDOC0199-000-A9
1-Slot Data Transport System (CSfC) 8 - 14 Operation
© 2024 Curtiss-Wright Defense Solutions Revision 2.0
Example
NOTE
Add the force option (---force) if changing format from ext4 to NTFS.
Format (NTFS) / mount partitions 1 through 4 of a 100GB RMC module.
Command:
rmcctl -p all -F --fs NTFS -M
Example
8.5.6 iSCSI
NOTE
Hardware and software encryption must both be active before initiating iSCSI operation.
The DTS1+ CSfC supports use of Internet Small Computer System Interface (iSCSI). It is
configured to use either Ethernet port 0 or port 1. The desired Ethernet port must have an active
link before running istarget.
1. To start iSCSI services:
a. Type serv -a 0 and press E
NTER key.
b. Type rmcctl --serv iSCSI0 --force and press ENTER key.
c. Type serv -a 2 and press ENTER key.
d. Type istarget --start and press ENTER key.
Example
2. To check iSCSI status, type istarget and press E
NTER key.
Example
3. To check RMC module services, type rmcctl and press E
NTER key.
cw_dts> rmcctl
[rmcctl]
RMC_S#: ins hcryp osdr p# size serv scryp osdm fmt mnt rem mntpoint
*********************************************************************************
RMC_S0: 1 1 1 1 25 GB NAS 0 na
ext4 1 0 rmc0p1
RMC_S0: 1 1 1 2 25 GB NAS 0 na
ext4 1 0 rmc0p2
RMC_S0: 1 1 1 3 25 GB NAS 0 na ext4 1 0 rmc0p3
RMC_S0: 1 1 1 4 25 GB NAS 0 na ext4 1 0 rmc0p4
[!rmcctl] OK
cw_dts> rmcctl
[rmcctl]
RMC_S#: ins hcryp osdr p# size serv scryp osdm fmt mnt rem mntpoint
*********************************************************************************
RMC_S0: 1 1 1 1 25 GB NAS 0 na
NTFS 1 0 rmc0p1
RMC_S0: 1 1 1 2 25 GB NAS 0 na NTFS 1 0 rmc0p2
RMC_S0: 1 1 1 3 25 GB NAS 0 na NTFS 1 0 rmc0p3
RMC_S0: 1 1 1 4 25 GB NAS 0 na
NTFS 1 0 rmc0p4
[!rmcctl] OK
cw_dts> istarget --start
[istarget]
RMC_S0_P1_L0: iqn.2015-05.net.cwnas.iscsi:rmc0p1 is_tgt_en=1 status=OK
[istarget] OK
cw_dts> istarget
[istarget]
RMC_S0_P1_L0: iqn.2015-05.net.cwnas.iscsi:rmc0p1 is_tgt_en=1 status=OK
[istarget] OK
To Next Page
Loading...