User Guide DDOC0199-000-A9
1-Slot Data Transport System (CSfC) 8 - 15 Operation
© 2024 Curtiss-Wright Defense Solutions Revision 2.0
Example
4. To stop iSCSI service type istarget --stop and press E
NTER key.
Example
8.6 PCAP
NOTE
Hardware and software encryption must both be active before initiating PCAP operation.
The DTS1+ CSfC supports use of the PCAP command to capture packets traveling over a
network. Two data streams may be captured at any one time (Ethernet ports 0 and 1). A unique file
name must be used with each recording in order to retain all recordings.
1. If not previously accomplished, type rmcctl --serv NAS and press E
NTER key.
2. If not previously accomplished, type rmcctl -F -M and press ENTER key.
NOTE
Both Ethernet ports can be used simultaneously to capture packets.
3. To start capturing packets:
a. Via Ethernet port 0, type pcap -i eth0 -s 0 --start file name 1 and press
E
NTER key.
Example
b. Via Ethernet port 1, type pcap -i eth1 -s 0 --start file name 2 and press
E
NTER key.
Example
4. To get pcap status, type pcap --stat and press E
NTER key.
Example
cw_dts> rmcctl
[rmcctl]
RMC_S#: ins hcryp osdr p# size serv scryp osdm fmt mnt rem mntpoint
*********************************************************************************
RMC_S0: 1 1 1 --- 100GB iSCSI na na na na 0 -----
[!rmcctl] OK
cw_dts> istarget --stop
[istarget]
RMC_S0_P1_L0: iqn.2015-05.net.cwnas.iscsi:rmc0p1 is_tgt_en=0 status=OK
[!istarget] OK
cw_dts> pcap -i eth0 -s 0 --start file name 1
[pcap]
Start PCAP recording on eth0 to /rmc_shares/rmc0/file name 1
recording started
[!pcap] OK
cw_dts> pcap -i eth1 -s 0 --start file name 2
[pcap]
Start PCAP recording on eth1 to /rmc_shares/rmc1/file name 2
recording started
[!pcap] OK
cw_dts> pcap --stat
[pcap]
PCAP recorder active
Interface eth0: Recorded 479232 Bytes (468K) to /rmc_shares/rmc0/file name 1
Interface eth1: Recorded 0 Bytes (0) to /rmc_shares/rmc0/file name 2
[!pcap] OK
To Next Page
Loading...