User Guide DDOC0199-000-A9
1-Slot Data Transport System (CSfC) 8 - 20 Operation
© 2024 Curtiss-Wright Defense Solutions Revision 2.0
NOTE
dtsxplus_image_year_month_day_ver_#_#_#
2. Type cmfwupdate -f dtsxplus_image_yyyy_mm_dd_ver_x_x_x.bin -s
dtsxplus_image_yyyy_mm_dd_ver_x_x_x.sig and press Y.
Crypto firmware update begins.
3. After update is complete, wait 10 seconds and then power unit OFF and back ON.
Example
8.10 Access from Windows as NAS Device
NOTE
When the partitions are formatted and mounted, they can be accessed from a PC running
Windows.
1. Log into the DTS1+ CSfC via SSH. Refer to paragraph 8.2.1.2 Ethernet.
2. Type rmcctl and press E
NTER key.
The RMC module must have NAS services assigned, be formatted (fmt=ext4 or NTFS).
and mounted (mnt=1). See Example.
Example
3. If required, format and mount RMC module as follows:
a. Type rmcctl --serv NAS and press E
NTER key
b. Type rmcctl -F -M and press ENTER key.
4. Type serv and press ENTER key to see if CIFS and NFS is enabled.
NFS enabled: nfs=1 NFS disabled: nfs=0
CIFS enabled: cifs=1 CIFS disabled: cifs=0
5. If NFS is disabled type serv --nfs 1 and press E
NTER key.
6. If CIFS is disabled type serv --cifs 1 and press ENTER key.
7. Open a File Explorer window.
8. Enter the IP address of the DTS1+ CSfC in the address bar.
Example \\192.168.1.1\
cw_dts> cmfwupdate -f cmfwupdate -f dtsxplus_image_yyyy_mm_dd_ver_x_x_x.bin -s
dtsxplus_image_yyyy_mm_dd_ver_x_x_x.sig
[cmfwupdate]
The Trusted Firmware Update takes approximately 10 minutes to complete.
During the process you shall not operate or powerdown the device.
Interrupting this process can brick the device leaving it inoperable.
Proceed? y/n: y
STATUS: Activity[...............................................................
................................................................................
.............................................................................]
Update Complete. Please wait 10 seconds to power cycle the unit.
status=OK
[!cmfwupdate] OK
cw_dts> rmcctl
[rmcctl]
RMC_S#: ins hcryp osdr p# size serv scryp osdm fmt mnt rem mntpoint
*********************************************************************************
RMC_S0: 1 1 1 -- 100GB NAS 0 na ext4 1 0 rmc0
[!rmcctl] OK
To Next Page
Loading...