Curtiss-Wright DTS1+ CSfC - Page 92

User Guide DDOC0199-000-A9
1-Slot Data Transport System (CSfC) 13 - 1 Command Line Interface
© 2024 Curtiss-Wright Defense Solutions Revision 1.0
Command Line Interface
NOTE
The CLI is used across various product lines, including the DTS1+ CSfC, DTS1+, DTS3+, DTS3,
and the XDS1+. As a result, the CLI uses DTS in place of the various unit nomenclaures in most
cases. Where the actual nomenclature is used, it refers to a command option that is only applica-
ble to that particular unit.
The Command Line Interface (CLI) is the primary method of communicating with and configuring
the DTS and / or RMC.
13.1 DTS
amnt............................................................................................ Auto mounter/starter control utility
cmfwupdate ................................................................................... Update DTS security processor
cmkey .......................................................................................................Manage key on encryptor
cmlog
..................................................................................... Read / clear crypto module error log
cmlogin ................................................................................ Login, Logout, initialize crypto module
cmpsk........................................................... Generate, write, or read PSK to / from crypto module
dhcpconfig.............................................................................................. Configure DHCP services
fdefaults ................................................................................................ Load factory default values
fupdate ...............................................................Boot into RAM disk image to perform field update
fwall .................................................................................................................Firewall control utility
help.......................................................................Display commands available to DTS admin user
ibit* ............................................................................................Perform initiated built-in test (IBIT).
info* ................................................................................................... View DTS system information
ipconfig*.......................................................................................................Configure IP interfaces
istarget ............................................................................................... Control iSCSI target services
ledctrl* ......................................................................... Set/get duty cycle and status for DTS LEDs
log........................................................................................................................ View DTS log files
mbit.................................................................................Perform maintenance built-in tests (MBIT)
nfsctl................................................................................................................ Change NFS options
ntpdate ....................................................................Retrieve system time and date from ntp server
password ............................................................................ Change login password for an account
pcap....................................... Perform packet capture (PCAP) recording to capture network traffic
rtp .......................................................................... RTP video stream recording control and status.
reboot ......................................................................................................................Reboot the DTS
sens*.......................................................................................................View DTS sensor readings
serv* ....................................................................................... DTS service control and status utility
shutdown .....................................................................................................................Halt the DTS
sysdate* .........................................................................................Configure system time and date
13.2 RMC
rmcctl* ................................................................................................................. RMC control utility
rmcfree*............................................... Display file system free/used info for RMC storage devices
rmcinfo*.......................................................................View and set RMC identification information
rmcpurge................................................................................. Purge all data on the drives of RMC
* Commands with SNMP service
13.3 Commands
Refer to following paragraphs for detailed information regarding CLI commands.