3. PRINTER FUNCTIONS3. PRINTER FUNCTIONS
KPM216H
153-
[Reference] ESC 0, ESC 3
[Example]
n3CSE
[Name] Set line spacing
[Format] ASCII ESC 3 n
Hex 1B 33 n
Decimal 27 51 n
[Range] 0 ≤ n ≤ 255
[Description] Sets line spacing to [ n × (vertical or horizontal motion unit)] inches.
[Notes] • The horizontal and vertical motion unit are specified by GS P or GS $D0.
Changing the horizontal or vertical motion unit does not affect the current
line spacing.
• The GS P or GS $D0 command can change the horizontal (and vertical)
motion unit. However, the value cannot be less than the minimum vertical
movement amount.
• In standard mode, the vertical motion unit is used.
[Default] n = 64
[Reference] ESC 0, ESC 2, GS P or GS $D0
[Example]
n4CSE
[Name] Set/reset italic mode
[Format] ASCII ESC 4 n
Hex 1B 34 n
Decimal 27 52 n
[Range] 0 ≤ n ≤ 1, 48 ≤ n ≤ 49
[Description] Turns italic mode on or off, based on the following values of n:
nnoitcnuF
84,0edomcilatiffosnruT
94,1edomcilatinosnruT
[Notes] • The printer can print any character in italic mode.
• When italic mode is turned off by setting the value of n to 0 or 48, the data
which follows is printed in normal mode.
• Italic mode can also be turned on or off using ESC !. Note, however, that
the last received command is the effective one.
[Default] n = 0
[Reference] ESC !
[Example]
To Next Page