3. PRINTER FUNCTIONS3. PRINTER FUNCTIONS
KPM216H
273-
• In standard mode, the following commands use x or y, regardless of
character rotation (upside-down or 90° clockwise rotation):
Commands using x : GS L, GS W.
Commands using y : ESC J.
• This command does not affect the previously specified values.
• The calculated result from combining this command with others is trun-
cated to the minimum value of the mechanical pitch or an exact multiple of
that value.
[Default] x = 204, y = 408 (for the 204 dpi model)
x = 300, y = 600 (for the 300 dpi model)
[Reference] ESC J, GS L, GS W, GS $D0
[Example]
,mVSG
nmVSG
[Name] Select cut mode
[Format]
ASCII GS V m
Hex 1D 56 m
Decimal 29 86 m
ASCII GS V m n
Hex 1D 56 m n
Decimal 1D 86 m n
Decimal 29 86 m n
[Range] m = 0, 48
m = 65, 0 ≤ n ≤ 255
[Description] Selects cut mode and executes the cut command. m selects cut mode as
follows:
mFoitcnun
84,0uclatoT.t
56xn[+noitisoptuc(deefmroFtuclatotdna)]tinunoitomlacitrev
[Notes] • This command is only enabled if set at the beginning of the line.
• The horizontal and vertical motion units are specified by GS P or GS
$D0.
[Default]
[Reference] ESC i, ESC m
[Example]
HnLnWSG
[Name] Set printing area width
[Format] ASCII GS W nL nH
Hex 1D 57 nL nH
Decimal 29 87 nL nH
To Next Page
Loading...
Need help?
General
