Custom Audio Electronics KPM 216 H User Manual

3. PRINTER FUNCTIONS
KPM216H
363-
tiBnO/ffOxeHlamiceD
noitcnuF
0
ffO000
.sutatsrepaPelbasiD
nO101
.sutatsrepaPelbanE
1
ffO000
.sutatsresUelbasiD
nO202
.sutatsresUelbanE
2
ffO000
.sutatSrorrEelbarevoceRelbasiD
nO404
.sutatSrorrEelbarevoceRelbanE
3
ffO000
.sutatSrorrEelbarevocernUelbasiD
nO808
.sutatSrorrEelbarevocernUelbanE
4- - -
.DEVRESER
5- - -
.DEVRESER
6- - -
.DEVRESER
7- - -
.DEVRESER
[Notes] • Once enable at least one byte of the FULL STATUS, for each change of
at least one of the bits which compose the required status, the status sent
in automatic from the printer will be so composed as follows:
1° Byte = 0x10 (DLE)
2° Byte = n
Next byte (depends how many bits are active in n)
[Reference] DLE EOT n
[Example]
}{SG
[Name] Reading of length paper (cm) available before virtual paper-end
[Format] ASCII GS { }
Hex 1D E1
Decimal 29 225
[Description] Reading of length (cm) paper available before virtual paper-end.
The command return a string pointing out how much paper is available, for
example if there are 5.1 m before the paper end, it will be:
‘510cm’
[Notes] • The lenght of residual paper reported is just as an indication
because tolerances and other factors are not taken into consideration
(paper thickness, roll core diameter, roll core thickness). The virtual paper-
end limit is set by the command GS µ.
• To set virtual paper-end limit, measure the length of the paper from near
paper end to the end of the roll, using several of them.
[Default]
[Reference]
[Example]

Custom Audio Electronics KPM 216 H Specifications

General

Brand	Custom Audio Electronics
Model	KPM 216 H
Category	Printer
Language	English