Custom Engineering KUBE II ETH - DESCRIPTION OF KEYS; Key Functions During Power Up and Standby

INSTALLATION
17
DESCRIPTION OF KEYS
Descrizione dei tasti
Beschreibung der tasten
Fast
push
ON/OFFLF
skip the
SETUP MODE
ON/OFFLF
ON/OFFLF
Hold
down
enter the
SETUP MODE
Fast
push
ON/OFFLF
perform the
FONT TEST
print the
SETUP report
POWER UP
Hold
down
ON/OFFLF
Hold
down
Hold
down
Fast
push
ON/OFFLF
Fast
push
ON/OFFLF
turn off
the printer
advance the paper
(manual feed)
STANDBY
Fast
push
NOTE: During power up, do not hold down the ON/
OFF key because the printer enters in a test mode
and it is unusable by keys; in this case, turn the printer
off and on again without pressing any key.
NOTA: Non tenere premuto il tasto ON/OFF perché la
stampante entra in una modalità di programmazione
nella quale non è più utilizzabile mediante i tasti; se
per errore si entra in questa modalità spegnere e riac-
cendere la stampante senza premere nessun tasto.
HINWEIS: Halten Sie nicht den ON/OFF Taste, weil
der Drucker in einem Modus, in dem Programmieren
nicht mehr mit den Tasten benutzt wird, wenn Sie
aus Versehen diesen Modus aus-und wieder ohne
jeden Tastendruck.