Custom Engineering KUBE II ETH - PRINTER SETUP; Printer Configuration Parameters

36
PRINTER SETUP
Setup stampante
Drucker setup
PRINTER NAME and
FIRMWARE RELEASE
KEYS FUNCTIONS
PRINTER STATUS
ETHERNET PARAMETERS
PRINTER SETUP
PRINTER TYPE .............................Kube
PRINTING HEAD TYPE.................T80
INTERFACE ...................................ETHERNET
PROGRAM MEMORY TEST..........OK
DYNAMIC RAM TEST....................OK
EEPROM TEST..............................OK
CUTTER TEST...............................OK
HEAD VOLTAGE [ V] = 24.34
HEAD TEMPERATURE [°C] = 24
POWER ON COUNTER = 256
PAPER PRINTED [cm] = 262169740
CUT COUNTER = 13965351
IP Address........................... : 192. 168. 10. 91
Subnet Mask ...................... : 255. 255. 240. 0
Default Gateway.................. : 192. 168. 0. 1
MAC Address .................... : 00-0E-E2-00-00-00
For advanced printer setup please
connect to: http://192.168.10.91
Autofeed....................................: CR disabled
Print Mode.................................: Normal
Chars / inch ...............................: A=15 B=20 cpi
Speed / Quality..........................: Normal
Printing Width............................: 76mm[80 PaperW]
Notch Alignment ........................: Disabled
Notch Threshold ..................... : 2.00
Notch Distance....................... : 0.00
Current ................................... : Low
Total Cut (ESC i)........................: Enabled
PaperEnd Buffer Clear..............: Disabled
PowerFail WakeUp Mode..........: LAST PWR State
Print Density..............................: 0%
[LF] key to enter setup
[OnOff] key to skip setup
KUBE II ETH rel.1.00
PRINTER PARAMETERS