Custom Engineering KUBE II ETH - Page 45

ADVANCED FUNCTIONS
45
< PRINTER > - Ethernet Interface
http://192.168.10.83
USER : <username>
Device Info Printer Settings Network Setup E-mail Setup Printer Support Login...
Printer Login...
Username:
Password:
Please insert Username and Password.
Once you enter the correct username and password, you will be
logged in to this printer configuration menus.
Login...
RealTime Status
Cover Open
Paper End
Near Paper End
Paper rolling
Autoload Paper
LF key pressed
Over temperature Error
Supply Voltage error
Cutter error
OnOff Key Pressed
Paper Jam
Notch Position Error
Notch Position OK
1
< PRINTER > - Ethernet Interface
http://192.168.10.83
USER : <username>
Device Info Printer Settings Network Setup E-mail Setup Printer Support Login...
< PRINTER > Printer Settings
Auto Feed:
PrintMode:
Char / Inch:
Speed / Quality:
Paper Width:
Notch Alignment:
Current:
Total Cut:
Buffer Clear At Paper End:
PowerFail WakeUp Mode:
Print Density:
CR disabled
Normal
A=15 B=20cpi
Normal
76mm [80PaperWidth
Notch Distance [mm]:
0.0
Disabled
Notch Threshold:
50%
Normal
Enabled
Disabled
LASR PWR State
0 %
Notch Autosetting:
Enable
Paper Characterization:
Enable
Apply Printer Settings Reset Printer Settings...
RealTime Status
Cover Open
Paper End
Near Paper End
Paper rolling
Autoload Paper
LF key pressed
Over temperature Error
Supply Voltage error
Cutter error
OnOff Key Pressed
Paper Jam
Notch Position Error
Notch Position OK
1
2
3
4