Safety Instructions
FOR YOUR SAFETY, OBSERVE THE FOLLOWING PRECAUTIONS WHEN SETTING UP
YOUR EQUIPMENT:
UPON INITIAL INSPECTION, IF THE UNIT APPEARS TO BE DAMAGED,
DO NOT INSTALL. CONTACT CYBER SWITCHING IMMEDIATELY.
FOLLOW ALL CAUTIONS AND INSTRUCTIONS MARKED ON THE
EQUIPMENT.
A SUITABLY RATED, LISTED BRANCH CIRCUIT BREAKER SHALL BE
PROVIDED AS PART OF THE BUILDING INSTALLATION.
ENSURE THAT THE VOLTAGE AND FREQUENCY OF THE POWER
SOURCE MATCH THE VOLTAGE AND FREQUENCY ON THE CYBER
SWITCHING EQUIPMENT ELECTRICAL RATING LABEL.
NEVER PLACE FOREIGN OBJECTS OF ANY KIND THROUGH OPENINGS
IN THE EQUIPMENT. CONDUCTIVE FOREIGN OBJECTS WILL PRODUCE
A SHORT CIRCUIT THAT CAN CAUSE FIRE, EQUIPMENT DAMAGE,
AND/OR ELECTRICAL SHOCK.
WHEN INSTALLING THE UNIT INTO A RACK, DO NOT BLOCK
VENTILATION OPENINGS OF THE UNIT.
THE SOCKET OUTLET SHALL BE INSTALLED NEAR THE EQUIPMENT
AND BE EASILY ACCESSIBLE.
DUAL SOURCE UNITS REQUIRE SEPARATE CIRCUITS TO INDIVIDUAL
BRANCH CIRCUIT PROTECTION.
MULTIPLE POWER SOURCES REQUIRE THAT ALL SOURCES BE
DISCONNECTED PRIOR TO SERVICING.
WARNING - TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK,
INSTALL IN A CONTROLLED ENVIRONMENT RELATIVELY FREE OF
CONTAMINANTS.
To Next Page
Loading...