EN
23
ADJUSTING THE SEAT The seat has a headrest that automatically adjusts the harness height
without the need to rethread it. The headrest may be adjusted up and down
through eleven positions to fit your baby.
The Aton M is shipped in the lowest position
with the Infant Body Support already in position.
Unbuckle the Harness and Chest Clip. Place the
child in the Infant Carrier, with their
back flat against the infant carrier seat back.
Adjust for your baby by pulling up on the
No Rethread Harness Adjuster at the top of the
headrest (a) while sliding the headrest up
until the Harness Slots are AT or JUST
BELOW your child's shoulders.
NOTE: Regularly check for proper harness
height as your child grows.
INFANT BODY SUPPORT The Infant Body Support
will help provide a better harness fit for smaller babies,
as well as stability for the torso. It must be used for
infants who weigh less than 11 lbs (5kg). It is placed
behind the headrest support under the childs bottom
so that it is touching the crotch buckle strap.
REMOVING THE INFANT BODY SUPPORT
In order to remove the body support, unfasten snaps
and pull it out from behind the bottom of the headrest
pad.
a
USING THE INFANT CARRIER
1
2
a
1
2
To Next Page
Loading...
Need help?
General
